FIBERGLASS


Preparation and application procedure

PREPARATION

Procedure:

  • On the fiberglass, sand with a sandblaster roller (with 40 grain sand paper).
  • Wash with acetone.
  • Rinse well.
  • Let the surface dry completely.

Note:

  • If the fiberglass is cracked and water has seeped under the resin, the useful life of your floor is over.
FINISH COATING

After preparing the surface…

Procedure:

  • Apply two coats of TexNov Acrylic Coating. Use a brush or roller with 10 mm bristles (24 hours between each coat).
  • Let the surface dry for 24 hours before applying the sealant.
SEALANT

After preparing the surface and applying the coating…

Procedure:

  • Apply 2 coats of TexNov Met-30 Sealant. Use a brush or roller with 10 mm bristles (24 hours between each layer).
  • Let the surface dry for 24 hours.

MAINTENANCE:

Clean the surface with TexNov Surface Preparer (3 water / 1 Preparer). Let dry and add a coat of Met-30 Sealant every 3 years or as needed. This should enable you to keep your surface in good condition.