CONCRETE PANEL


Preparation and application procedure

PREPARATION
Concrete Panel (Applicable procedure to Durock or Permabase brands)

Procedure :

  • Make sure there is no dirt on the surface and that it is completely dry.
  • Half and half joint: Install a 3 oz. TexNov fiberglass mesh buried in a coat of All-Purpose Texnov Polymere or Texnov 200.
  • Install a 6 oz. TexNov fiberglass mesh over the entire surface buried in a coat of All-Purpose Texnov Polymere or Texnov 200.
  • Let the surface dry over a 24/ 48-hours of good weather before applying the finish coating.
FINISH COATING
Procedure :

  • Install an acrylic finish coating coats Sand-Tex or Rus-Tex Acrylic Coating finish coat using a trowell or 2 coats of Texnov Acrylic Coating using a brush or a roller with 10 mm bristles. Allow 24 hours of dry time between each coat.
  • Let the surface dry over a 24/ 48-hours of good weather before applying the sealant.
SEALANT
After preparing the surface and applying the coating (if necessary)…

Procedure :

  • When following this procedure on a floor, apply 2 coats of Met-30 Sealant to the panel. use a brush or roller with 10 mm bristles. Allow 24 hours of dry time between each coat.
  • Let the surface dry over a period of 24 hours of good weather.

MAINTENANCE :

Clean the surface with Texnov Surface Preparer (3 water/ 1 preparer). Let dry and add a coat of Met-30 Sealant every 3 years or as needed. This should enable you to keeo your surface in good condition.