CONCRETE PANEL


Preparation and application procedure

PREPARATION
Concrete panel ( Durock or Permabase brand)

Procedure :

  • Make sure there is no dirt on the surface and that it is dry.
  • Sheet seal: install a 3 oz. fiberglass mesh. TexNov and embed it in a layer of TexNov or TexNov 200 All Purpose Polymer.
  • Install a 6 oz fiberglass mesh. TexNov over the entire surface embedded in a layer of TexNov or TexNov 200 All Purpose Polymer.
  • Allow the surface to dry for 24-48 hours in good weather before applying the finishing coat.
FINISH COATING
Procedure :

  • Install one coat ofSand-Tex or Rus-Tex Acrylic Coating (use the trowel) OR two coats ofTexNov Acrylic Coating and use a brush or roller with 10 mm bristles, allowing 24 hours of drying time between each coat.
  • Allow the surface to dry for 24-48 hours in good weather before applying the sealant.
SEALANT
After having done the surface preparation and the application of the coating (if necessary)…

Procedure :

  • For projects on floors, install 2 coats of Met-30 Sealer, using a brush or roller with 10 mm bristles. Leave 24 hours between each coat.
  • Leave the surface to dry for 24 hours in good weather.

MAINTENANCE :

Clean the surface with TexNov Surface Preparer by diluting 9 parts water to 1 part product. Let dry and add a coat of Met-30 Sealer every 3 years or as needed, which should keep your surface in good condition.