ACRYLIC COATINGS


Preparation and application procedure

PREPARATION
Procedure:

  • Thoroughly rinse the surface with a pressure washer.
  • Apply TexNov Surface Preparer, following the dilution guide.
  • Vigorously brush the surface and allow 15 minutes for it to act.
  • Rinse the surface thoroughly with a pressure washer.
  • Let the surface dry over a period of 48 hours of good weather before applying the finish coat.
FINISH COATING
After preparing the surface…

Procedure:

  • Apply two coats of TexNov Acrylic Coating.
    Use a brush or roller with 10 mm bristles (24 hours between each coat).
  • Let the surface dry for 24 hours before applying the sealant.
SEALANT
After preparing the surface and applying the coating (if necessary) …

Procedure:

  • Apply 2 coats of TexNov WRS-40 Sealant (waterproof sealant) to waterproof the surface. Use, brush or roller with 10 mm bristles or a sprayer (24 hours between each coat). (Optional)
  • Let the surface dry for 24 hours.

MAINTENANCE :

Clean the surface with TexNov Surface Preparer (9 water / 1 Preparer). Let dry and add a coat of WRS-40 Sealant every 5 years or as needed. This should enable you to keep your surface in good condition.